RAD Data comm 100 Dokumentacja Pobierz pdf (Strona 247)

Installation and Operation Manual Chapter 7 Application Tutorial

Egate-100 Ver. 4.0 User and Management Traffic Separated by VLAN 7-3

After installing the unit, refer to the section

Configuring the Egate-100

for

configuration instructions.

Mounting the Unit

Egate-100 is designed for installation as a desktop unit or mounted in a rack.

• For rack-mounting instructions, refer to the installation kit manual.

• If Egate-100 is to be used as a desktop unit, place and secure the unit on a

stable, non-movable surface.

Installing Fiber Optic SFP Modules

Egate-100 uses SFP modules with LC fiber optic connectors that provide

hot-swappable industry-standard interfaces.

Third-party SFP optical transceivers must be agency-approved, complying with the

local laser safety regulations for Class 1 laser equipment.

³ To install the SFP modules:

1. Lock the wire latch of each SFP module by lifting it up until it clicks into place,

as illustrated in

Figure

7-2

Some SFP models have a plastic door instead of a wire latch.

Figure

7-2. Locking the SFP Wire Latch

2. Carefully remove the dust covers from the SFP slot.

3. Insert the rear end of SFP into the socket, and push slowly backwards to

mate the connectors until the SFP clicks into place. If you feel resistance

before the connectors are fully mated, retract the SFP using the latch wire as

a pulling handle, and then repeat the procedure.

4. Remove the protective rubber caps from the SFP modules.

Note

Warning

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 317 318

Brak uwag

RAD Data comm 100 Dokumentacja Strona 247