RAD Data comm ASMI-450 Instrukcja Użytkownika Pobierz pdf (Strona 15)

User's Manual Chapter 2 Installation and Operation

LRS-24 RADview/TDM Pre-configuring for Network Management 2-3

Parameter Possible Values / Remarks

Date Date on the internal CM-2 real-time clock.

To change the date, type the correct date according to the format: YYY-MM-DD

(year:month:day). When done, press <Enter> to move to the next field.

IP Address IP address assigned to CM-2 module, in dotted-quad format.

When assigning the IP address, remember that the following 12 IP addresses

must be reserved for I/O modules (the first address is associated with I/O slot 1

and the last address with slot 12).

Four groups of digits in the range of 0 through 255, separated by periods.

IP Mask Subnet mask corresponding to the IP addresses used by the CM-2 module.

Dotted-quad format

Read Community Name of SNMP community that has read-only authorization (the CM-2 SNMP

agent accept only getRequest and getNext Request command from management

stations using that community).

Up to seven alphanumeric characters

Read/Write Community Name of SNMP commnity that has read-write authorization )the CM-2 SNMP

agent accepts setRequest commands from management stations using that

community).

Up to seven alphanumeric characters

Trap Community Name of SNMP community to which the CM2 SNMP agent send traps.

Up to seven alphanumeric characters

Default Gateway IP Address of default gateway to be used by CM-2 module to contact a

management station located ona diffeent IP network.

If the CM-2 module and the management staton are located on the Ip same

network, enter 0.0.0.0.

Dotted-quad format

Burn in MAC Address Factory MAC address used by BOOTP server to declare the IP address of the

CM-2.

BOOTP ON/OFF Toggle to select BOOTP.

To maintain backwards compatibility (with any LRS-12 version) set BOOTP

ON/OFF to OFF.

Otherwise, BOOTP ON/OFF should be set to ON.

In either case, BOOTP ON/OFF should be set to OFF while setting the IP address.

ON-use BOOTP

OFF- no BOOTP

Default value: OFF

BOOTP Time Out Maximum waiting time for a BOOTP response.

1, 2, 3, 4, 6, 8, 10, 15, 20 seconds

Default value: 10 seconds

BOOTP Retries Number of time to rety sending a request for the BOOTP server.

3, 4, 5, 10, 15, 20, 25, 30 times

Default value: 30 times

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 159 160

Komentarze do niniejszej Instrukcji

Brak uwag

RAD Data comm ASMI-450 Instrukcja Użytkownika Strona 15

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking RAD Data comm ASMI-450