RAD Data comm FCD-X21 Instrukcja Instalacji Pobierz pdf (Strona 186)

Appendix D Command Language Installation and Operation Manual

D-24 Supervisory Terminal Commands FCD-E1

DEF DOWNLOAD

Purpose

Define the inband management communication parameters. Refer to Table D-6

for the parameter description, allowable ranges and configuration guidelines.

Syntax

DEF DNLOAD {ML SL}

Use

1. To define the inband management communication parameters for the link,

type:

DEF DNLOAD ML<Enter> or DEF DNLOAD SL<Enter>

The first line of the data form is displayed. A typical line is shown below:

DNLOAD MODE

NONE

If you specify the sublink for an FCD-E1/*, you will see ERROR 054 (illegal

parameter for current configuration).

2. Select the desired mode, and then press <Enter>.

If the DEDIC TS mode is selected the following line of the data form appears:

TS_NUM SPEED

1 8

3. Select the desired timeslot and management data rate, in kbps. For sublinks,

always select 8 kbps.

4. When done, press <Enter> to end.

If the FRAME RL mode is selected the following line of the data form appears:

TS_NUM SPEED

1 64

5. Select the desired timeslot. The management data rate is always 64 kbps. This

selection is available for the main link only.

6. When done, press <Enter> to end.

DEF DP

Purpose

Define the communication parameters of the dial-out port and control the use of

the call-out function. The communication parameters of the dial-out port can be

different from the communication parameters of the supervisory port, which are

selected by means of the DEF SP command.

Syntax

DEF DP

Note

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 223 224

Brak uwag

RAD Data comm FCD-X21 Instrukcja Instalacji Strona 186