3 Using RAD Vmux trunking over BGAN
To set up your computer and BGAN terminal for RAD Vmux:
1. Connect the central site Vmux-110 via FXO interfaces to the PBX or voice switch.
2. Connect the remote site Vmux-110 via FXS interfaces to phones or faxes, and via Ethernet
interface to the BGAN terminal.
3.
RAD Vmux requires a static IP address to be configured for use on both the network and the
terminal. Therefore, you must obtain a static IP address from your service provider.
If you are using the Hughes 9201, you must configure the Vmux-110 with the static IP
address 192.168.128.101 (or another from the same range, if in use).
4. Open UDP input port 2142 to pass voice traffic.
To start a terminal session:
1. Connect a terminal to the CONTROL connector of Vmux-110.
2. Turn on the control terminal PC and set its port parameters to the default communication
parameters (One start bit, Eight data bits, One stop bit, No parity, No flow control, VT100
emulation).
3. Power-up the Vmux-110.
4. After the boot sequence (which lasts approximately 50 seconds), press <Enter> several times (the
rate is detected automatically).
5. Proceed with the management session
To configure basic parameters:
1. From the Main Menu, select Configuration > Quick Setup.
2. Configure the desired parameters (see table below):
Parameter Description Possible values
Host IP address Defines Vmux-110’s IP address (for both
management and voice traffic).
Default: 0.0.0.0
Host subnet mask Defines Vmux-110’s subnet mask.
Default: 0.0.0.0
Default gateway
Defines default gateway. Default: 0.0.0.0
Destination IP IP address of the destination Vmux-2100
group or Vmux-110/210.
Default: 0.0.0.0
Destination bundle Number of the destination bundle.
1…30
Default: 1
Save
Configures a basic voice application in the temporary DB,
including a single bundle (according to the specified Destination
IP and Destination Bundle); all other parameters retain default
values, including the analog ports connected to this bundle
Notes:
• The Save command erases previously configured bundles (in the
event that bundles were configured manually through the
Bundles menu).
• In addition to selecting Save, you must press @ to save the
changes in the database. Otherwise, all changes will be lost.
3. Select Save
4. Bundle connectivity on the Vmux should be configured “without PING” since BGAN in not
transparent to ICMP packets. (This should be configured via Main Menu > Configuration >
Bundles > Edit > Connectivity Parameters)
5. Type @ and confirm the data base update.
(108 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji